Acronis Access Advanced - Administrator's Guide Uživatelský manuál stáhnout pdf (Strana 93)

2. In the Access installer, choose Custom, and select only Acronis Access Server and Acronis Access

Gateway Server and continue with the installation procedure.

3. After finishing the installation procedure, proceed with going through the Configuration Utility.

a. You will be prompted to open the Configuration Utility. Press OK.

b. On the Access Server tab:

 Enter the address and port on which your Acronis Access management server will be

reachable (i.e. 10.27.81.3 and 10.27.81.4).

 Select your certificate. This should be the same SSL certificate that is tied to the DNS

address of the load balancer.

 Press Apply.

Note: If you don't have a certificate, a self-signed certificate will be created by Acronis Access. This

certificate should NOT be used in production environments.

c. On the Gateway Server tab:

 Enter the address and port on which your Gateway Server will be reachable (i.e.

10.27.81.10 and 10.27.81.11).

 Select your certificate.This should be the same SSL certificate that is tied to the DNS

address of the load balancer.

 Press Apply.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 258 259

Žádné komentáře

Acronis Access Advanced - Administrator's Guide Uživatelský manuál Strana 93