ACRONIS Backup & Recovery 11 Uživatelská příručka Strana 39

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 379
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 38
39 Copyright © Acronis, Inc., 2000-2011
To create the volume structure manually
1. Boot the machine from a Linux-based bootable media.
2. Click Acronis Backup & Recovery 11. Then, click Run management console.
3. On the toolbar, click Actions, and then click Start shell. Alternatively, you can press
CTRL+ALT+F2.
4. If necessary, examine the structure of volumes which are stored in the archive, by using the
acrocmd utility. Also, you can use this utility to mount one or more of these volumes as if they
were regular volumes (see "Mounting backup volumes" later in this topic).
5. Create the volume structure according to that in the archive, by using the mdadm utility (for MD
devices), the lvm utility (for logical volumes), or both.
Note: Logical Volume Manager utilities such as pvcreate and vgcreate, which are normally available in
Linux, are not included in the bootable media environment, so you need to use the lvm utility with a
corresponding command. For example: lvm pvcreate, lvm vgcreate, and lvm lvcreate.
6. If you previously mounted the backup by using the acrocmd utility, use this utility again to
unmount the backup (see "Mounting backup volumes" later in this topic).
7. Return to the management console by pressing ALT+F1.
(Do not reboot the machine at this point. Otherwise, you will have to create the volume
structure again.)
8. Click Recover, then specify the path to the archive and any other required parameters, and then
click OK.
Note: This procedure will not work if you connect to Acronis Backup & Recovery 11 Bootable Agent remotely,
because the command shell is not available in this case.
Example
Suppose that you previously performed a disk-level backup of a machine with the following disk
configuration:
The machine has two 1-gigabyte and two 2-gigabyte SCSI hard disks, mounted on /dev/sda,
/dev/sdb, /dev/sdc, and /dev/sdd, respectively.
The first and second pairs of hard disks are configured as two MD devices; both are in the RAID-1
configuration, and are mounted on /dev/md0 and /dev/md1, respectively.
A logical volume is based on the two MD devices and is mounted on
/dev/my_volgroup/my_logvol.
Zobrazit stránku 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 378 379

Komentáře k této Příručce

Žádné komentáře